Angle of Repose for Solid Bulk Cargoes
Angle of repose under the IMSBC Code: the cohesive and non-cohesive distinction in Appendix 3, the section 5.4 trimming ladder, and the test methods in section 6.
The angle of repose is the maximum slope angle a non-cohesive granular material holds without sliding, and in the IMSBC Code it is a trimming parameter rather than a general cargo property. Its purpose is to decide how level a cargo surface must be left, because a low angle of repose means a surface that can shift and take the centre of gravity with it.
The full article will cover the distinction that governs whether the parameter applies at all. Appendix 3 paragraph 1.1 lists the cargoes that are non-cohesive when dry, and paragraph 1.3 provides that everything not listed is cohesive and should be treated as cohesive until otherwise shown. Section 5.3.2 then excludes the angle of repose from the schedules of cohesive cargoes, which is why so many entries read Not applicable.
It will cover the graduated trimming requirements in section 5.4 for non-cohesive cargoes, the test methods in section 6 including the tilting box and the shipboard method, and the common error of quoting a trade figure for a cargo whose schedule declines to give one.