Cylinder lubrication and feed rate

Cylinder oil feed rate control, base number selection against fuel sulphur, the low-load 1.2 g/kWh guidance, and drain oil monitoring after the 2020 sulphur cap.

Cylinder lubrication on a two-stroke marine diesel engine delivers a metered quantity of oil to the liner running surface to separate the piston rings from the liner, neutralise acidic combustion products and carry away deposits. The feed rate and the oil’s base number are the two variables under the operator’s control, and both were re-set by the change in fuel sulphur on 1 January 2020.

Under sustained low load the guidance is to reduce rather than increase feed. MAN’s guidance for the 5 to 40 percent load band is to set the feed rate preferably to 1.2 g/kWh, raising it only during load changes, manoeuvring or if cylinder condition deteriorates, and it notes that below roughly 30 percent load excessive cylinder lubrication can occur. On low sulphur fuel the Alpha Cylinder Control factor cannot meaningfully be assessed, because lubrication never enters the active area.

Base number is selected against fuel sulphur rather than a legacy default. A high base number oil burned on low sulphur fuel carries a calcium carbonate detergent package with no acid to react with, and the unreacted additive deposits as ash on the piston topland and in the ring grooves. The full article will cover feed rate control modes, sweep testing, and scavenge drain oil iron and base number monitoring. See cold corrosion in two-stroke engines and slow steaming.