Wind Turbine Installation Vessels

The jack-up and floating vessels installing offshore wind turbines: leg and spudcan design, crane capacity against turbine rating, and the payload-per-load metric.

A wind turbine installation vessel carries turbine components to an offshore site and lifts them into place, usually from a jacked-up position where the hull is raised clear of the water on legs standing on the seabed. The type exists because turbine components have outgrown every other lifting platform, and its specification has been driven upward by turbine rating rather than by anything in the marine market.

The full article will cover the engineering. The legs and their spudcans, the jacking system and its holding capacity, the preload procedure and the punch-through risk it guards against, the water depth envelope, and the transition to floating installation with dynamic positioning where the seabed will not take a jack-up. Crane capacity, hook height and radius follow from the largest single component rather than from the total lift.

It will treat the commercial metric the sector actually uses, which is neither deadweight nor crane capacity but the number of complete turbine sets a vessel carries per load, since transit time between field and marshalling port dominates the installation schedule. The article will cover the current fleet, its capacity ladder and the ordering cycle that has doubled several operators’ fleets in a short period.